Hey
Is there a way to temporarily disable a Bridge workflow? I need to perform a mass upload in my sheet and I need the Bridge routines turned off temporarily.
Kelly
@Kelly Moore What if you were to temporarily disconnect the integrations? Do you think that'd work?
Hey Ayelet
Yes, I thought about that - I wasn't sure if I did it that the workflows would remain unaffected. In the end, I'm taking out the runtime event that is associated with the Get Row in every routine. It will throw an error but not run. It's a pain- more than 25 flows are affected across 3 sheets. Submit your enhancements for the toggle button on workflows AND also on Workspaces. It would have been great to turn off my 3 workspaces and be done with it.
Thanks for the response.
Another good enhancement, along this same line, would be basic "enable", "disable", "start", "stop", and "log" buttons available at the All Workflows screen next to each workflow would be wonderful. Along with an indicator of what was currently running, and the trigger conditions.
Oh and rename. My kingdom for rename.
:-)
I know how to set up and create a Dynamic view and put this in WorkApps but what I don't know is how to share it with 600 people. In General Setting "Restrict view by current user is "Submitted by", 600 people can view their "Own" submissions. In Sharing Tab , "Shared Domain" if I add our work domain, " "abc.com", why do…
I'd like to integrate some of the task information from two totally different smartsheet schedules into the primary/main project schedule but not all of the tasks in the two different schedules. Is there a way to integrate just some of the tasks from the different schedules and also have predecessor relationships to tasks…
I have a large number of assets that have been provisioned through Control Center. I want to install a formula in one cell in a specific column. I thought I could update the template in the source folder of the blueprint and publish it, however, that functionality has been removed or I can't quite figure out how to do it.…