Smartsheet Bridge: Junction States connecting to the same next Junction

Jacob Rossi

Hello,
I've been working with Bridge for a little while and one thing I can't seem to figure out is how you can have a junction with multiple paths all route back to another junction. What I have had to do is essentially duplicate steps under each junction path in order to accomplish the same thing. I've seen screenshots of others who have done this but I haven't been able to figure it out.

What I want to do is have a junction that checks a piece of data then branches out to do specific tasks based on the result and then link back up to the next junction and so on. I've attached an example that I've seen but I can't figure out the steps to link these together like this.

Paul Newcome

Lets say you have "Junction Split A" and "Junction Split B". You run a few steps through each of them and then want to tie both into "Combined State".

Go ahead and build everything out though "Junction Split A" all the way down through "Combined State". Then you would click on the last unique module in "Junction Split B", hold down the "Alt" key, then click on the "Combined State" state. It may take a try or two. Sometimes it can be a little finicky, but that should work.