Sign in to join the conversation:
Hey
Is there a way to temporarily disable a Bridge workflow? I need to perform a mass upload in my sheet and I need the Bridge routines turned off temporarily.
Kelly
@Kelly Moore What if you were to temporarily disconnect the integrations? Do you think that'd work?
Hey Ayelet
Yes, I thought about that - I wasn't sure if I did it that the workflows would remain unaffected. In the end, I'm taking out the runtime event that is associated with the Get Row in every routine. It will throw an error but not run. It's a pain- more than 25 flows are affected across 3 sheets. Submit your enhancements for the toggle button on workflows AND also on Workspaces. It would have been great to turn off my 3 workspaces and be done with it.
Thanks for the response.
Another good enhancement, along this same line, would be basic "enable", "disable", "start", "stop", and "log" buttons available at the All Workflows screen next to each workflow would be wonderful. Along with an indicator of what was currently running, and the trigger conditions.
Oh and rename. My kingdom for rename.
:-)
I’m hoping to find out whether there’s a way to automatically pull in only the tasks assigned to me from a report or Smartsheet into Outlook, so I don’t miss anything. I work mainly in Outlook, so having my tasks synced or visible there would be really helpful. Ideally, I can currently bring in all tasks from sheet but…
I'm looking to integrate SmartSheet with Entra ID. The goal is to configure SSO and have auto-provisioning. I've followed some of the steps provided already and seem to do what is expected? Is there more documentation somewhere that can provide some clarity?
Hello, I come with an issue the likes of which I haven't seen before. On 12/11, numerous Pivots in workspaces I own all broke. These Pivots house employees as columns, and their respective training hours. The Activity Log showed that all data suddenly went to zero. Then, over the next few seconds, new columns of the same…
