Run Log error in Bridge / Smartsheet integration
Hi - I am trying to follow the instructions on how to copy partial rows to another sheet using a Bridge workflow (https://help.smartsheet.com/articles/2482720-copy-partial-rows-using-Bridge). I'm not getting very far before hitting a run log error. I've included the error and the step where it's occurring. I've tried using different sheets and deleting and starting over several times, but I keep getting the same "Required parameter Sheet has not been defined." Is anyone familiar with this error?
Set up the workflow modules
Before getting started with the module setup, trigger the workflow to create a Run Log entry.
- Go to your source sheet.
- Change the trigger column’s value to Complete. In this example, the workflow is triggered from the Status A column.
- Save the sheet.
There will now be a workflow run entry in the Run Log of your Bridge workflow. Use the trigger data to populate the first module.
Answers
-
Please disregard. I figured it out. Definitely a rookie mistake. I didn't realize the error was for later steps I hadn't fully set up yet. I needed to keep building out the workflow using data from the trigger section.
-
Hey @jheyano
I'm glad you were able to figure it out - thank you for posting what you found, it may help someone else!
Need more help? 👀 | Help and Learning Center
こんにちは (Konnichiwa), Hallo, Hola, Bonjour, Olá, Ciao! 👋 | Global Discussions
Categories
- All Categories
- 14 Welcome to the Community
- Customer Resources
- 64.6K Get Help
- 433 Global Discussions
- 136 Industry Talk
- 465 Announcements
- 4.9K Ideas & Feature Requests
- 143 Brandfolder
- 147 Just for fun
- 63 Community Job Board
- 466 Show & Tell
- 32 Member Spotlight
- 2 SmartStories
- 298 Events
- 36 Webinars
- 7.3K Forum Archives