changing datamesh configurations

Alta

I ran a datamesh configuration and after I ran it, I decided that the next time it runs I would like to add an additional column to the configuration to match. How can I go into the configuration and update it or do I have to create a whole new configuration?

Genevieve P.

Hi @Alta

You can add new columns to the Source and Destination sheets, then update the Config to add these in, no problem!

Once you've created the columns and saved them in your sheets, click on the gear icon in the right of the DataMesh config page for your specific configuration.

Then click on Previous down in the bottom right to work your way back to the "Map Sheet Columns" tab.

If you click on the field dropdown you should now see the New Column available to map:

Cheers,

Genevieve

Alta

Thanks so much!

Brooke Weber

THANK YOU for this post! I didn't realize I needed to "work backwards" to update the settings, as Pivot reports open right to the edit setting. This is extremely helpful, thank you!

Cathy Betzer

Very helpful. I agree with @Brooke Weber - selecting "previous" to edit was not intuitive. Thank you.