Blueprint not spinning up Generate Doc
I have a Map setup to Generate a doc in one of my sheets. This is connected to a blueprint and when I use the blueprint to spin up a new project the mapping in the sheet disappears, is there something I am doing wrong? Or a setting that I need to enable in my blueprint for this to work correctly?
Best Answer
-
You are not doing anything wrong.
doc blueprint matching does not currently carry over when copied…
it is supposedly on the roadmap:
https://community.smartsheet.com/discussion/96322/document-builder-mapping-transfer
Answers
-
You are not doing anything wrong.
doc blueprint matching does not currently carry over when copied…
it is supposedly on the roadmap:
https://community.smartsheet.com/discussion/96322/document-builder-mapping-transfer
-
@Leibel S Thanks for the input. I thought it was probably something that wasn't available yet, but wanted to check with my fellow community peers.
Categories
- All Categories
- 14 Welcome to the Community
- Customer Resources
- 66.7K Get Help
- 438 Global Discussions
- 152 Industry Talk
- 497 Announcements
- 5.3K Ideas & Feature Requests
- 85 Brandfolder
- 155 Just for fun
- 77 Community Job Board
- 508 Show & Tell
- 34 Member Spotlight
- 2 SmartStories
- 307 Events
- 36 Webinars
- 7.3K Forum Archives