Data Mesh: Source report becomes "Not Found" after it's selected during Config creation
This is happening across multiple browsers and accounts, but just for one particular report. I can't use it in a data mesh and I'm seeing the message "Something went wrong. Please try again later."
I go to New Config - Select Source sheet - and the report I want is visible, but then one of two things will happen:
A. I select it, but "Next" is grayed out, I can't proceed, and get the error message. -OR-
B. I select it and can proceed to choose the target sheet, but on the screen for Map Sheet Columns, the source sheet now says "Not Found" and I see the error message.
NOTE: This is the first time I've created a report that pulls from a sheet summary rather than sheet columns. Are those problematic to Data Mesh for some reason?
Thanks in advance!
Best Answer
-
Hi @malden
Currently Sheet Summary type of Reports are not supported in add-ons such as Data Shuttle or DataMesh. Here's more information: Create a new DataMesh Config - Select the source
Cheers,
Genevieve
Need more help? 👀 | Help and Learning Center
こんにちは (Konnichiwa), Hallo, Hola, Bonjour, Olá, Ciao! 👋 | Global Discussions
Answers
-
Hi @malden
Currently Sheet Summary type of Reports are not supported in add-ons such as Data Shuttle or DataMesh. Here's more information: Create a new DataMesh Config - Select the source
Cheers,
Genevieve
Need more help? 👀 | Help and Learning Center
こんにちは (Konnichiwa), Hallo, Hola, Bonjour, Olá, Ciao! 👋 | Global Discussions
-
Thanks @Genevieve P.
Categories
- All Categories
- 14 Welcome to the Community
- Customer Resources
- 64.5K Get Help
- 430 Global Discussions
- 136 Industry Talk
- 465 Announcements
- 4.8K Ideas & Feature Requests
- 143 Brandfolder
- 146 Just for fun
- 63 Community Job Board
- 466 Show & Tell
- 32 Member Spotlight
- 2 SmartStories
- 301 Events
- 39 Webinars
- 7.3K Forum Archives