Global Update hanging up
Performing a Global update to add a column to sheets generated from a blueprint. It got only a little of the way through the update and has paused for about 20 minutes now. I briefly saw a pink box in the lower right corner that said something very non-specific about an error.
Is there a place to go check for an error log? Is there a way to get the update to skip a single sheet or batch of sheets so it can continue to update the rest? Is there a good way to terminate the process and start again?
Answers
-
FYI: closing my browser halted the update and it is sitting in a "partially updated" status.
-
I have a situation similar to @Andy Vohs, although my browser has remained open. My Global Update is definitely stuck and has been in this screen below for over 20 minutes. I hate to refresh the browser for fear it will not update every project. Has anyone else run into this? Any suggested solutions?