Global Update hanging up
Performing a Global update to add a column to sheets generated from a blueprint. It got only a little of the way through the update and has paused for about 20 minutes now. I briefly saw a pink box in the lower right corner that said something very non-specific about an error.
Is there a place to go check for an error log? Is there a way to get the update to skip a single sheet or batch of sheets so it can continue to update the rest? Is there a good way to terminate the process and start again?
Answers
-
FYI: closing my browser halted the update and it is sitting in a "partially updated" status.
-
I have a situation similar to @Andy Vohs, although my browser has remained open. My Global Update is definitely stuck and has been in this screen below for over 20 minutes. I hate to refresh the browser for fear it will not update every project. Has anyone else run into this? Any suggested solutions?
Categories
- All Categories
- 14 Welcome to the Community
- Smartsheet Customer Resources
- 63.4K Get Help
- 394 Global Discussions
- 213 Industry Talk
- 449 Announcements
- 4.6K Ideas & Feature Requests
- 141 Brandfolder
- 132 Just for fun
- 131 Community Job Board
- 453 Show & Tell
- 30 Member Spotlight
- 1 SmartStories
- 293 Events
- 35 Webinars
- 7.3K Forum Archives